NK1103 motor is a micro motor designed for drone and Tiny Whoop. This motor assembled with high quality Arc N52H Magnet, Genuine NMB Bearing, 0.15mm Nippon Steel Silicon Steel and 7075 High Quality CNC Material. Furthermore, the motor has been balanced by Motion Balancing
Machine so you will see the colored balancing mud in the motor.
Quality Motor Best for 80-110 frames
Neat copper wire winding
This NK1103 motor made with Japan Imported Copper Wire, Genuine NMB Bearings, 0.15mm Nippon Steel Silicon Steel.
All RCX NK1103 Motors Are Factory Balanced!!
Unlike most other brands who do not balance their motors (or just lie that the motor has been balanced). All of our NK1103 motors have been balanced by Dynamic Balancing Machine. It takes time so the production quantity (bottleneck) is limited. You will see the balancing mud in most of RCX SE-Motors, it is the proof of *balanced*.
M2 - Φ9 Motor Mounting
Install the T-Propeller using two M2 screws
You can mount the mini propeller directly using two pieces M2 screws easily and securely. The motor also soldered with SH 1.25mm (also known as JST-1.25) connector for easier to plug into the flight controller.
With 9mm mounting in M2 screw size, it will fit most micro frames in the market.
Thrust Test Table
Please refer to both Thrust Test Table and the Video Thrust Test (by Third Party) below. You must be careful when the temperature is over 80°C after each flight because the motor might be overused.
Where can you get a such high quality motor for such a low price? We are losing money to sell this motor because we want to beat our competitors. We may adjust (raise) the price anytime so you are better to buy as many as you can to save money now.
- Model: NK1103
- KV: 10000KV
- Weight: Approx. 3.4g (net weight)
- Cable Length: 5cm (good for Tiny Whoop Size)
- Shaft Diameter: 1.5mm
- Stator Diameter: 11mm
- Stator Length: 3mm
- Configuration: 12N14P
- Motor Dimensions: Φ--mm
- ldle Current: 0.00A @ 10V
- Internal Resistance: 0.00Ω
- Suitable ESC: 10-15A (depends on the propeller and battery you use)
- Suitable Battery: 1-2S Li-Po (refer to thrust test table and videos)
Bearing and motor shaft are common consumable parts of a motor. You are recommended to replace a new one from time to time after a period of flight time. Replacement of bearings and motor shaft could sometime fix mirror issues. It is better for you to keep some for spare.
- 1 x RCX NK1103 Motor
- 1 x Set of M2*4 Screw
- Given AS IS condition, you may need to buy the screws which are suitable for your frame.
Notice: This question "my new motor is hard to turn by finger, it is not smooth so it is defective!" has been asked many times. Please click here for the answer. We are so tired to answer this question by email, please read it before you purchase.